John Deere DH54 Series Offset Disks
Disks
Your Preferred Location
Features
-
PTO HP: 175 - 225 hp (130.5 - 167.8 kW)
-
Working Width: 10 ft. (3.0 m)
-
Hitch: Cast link
Specifications
Available blade sizes - Blade option one: |
762x12.7 mm 30x0.5 in. |
Available blade sizes - Blade option two: |
813x12.7 mm 32x0.5 in. |
Disk blades - Quantity: |
26 |
Disk blades - Spacing: |
33 cm 13 in. |
Disk blades - Type: |
Notched (front) Notched (rear) Standard |
Disk gangs - Axle material: |
Round heat treated alloy steel threaded on both ends |
Disk gangs - Axle size: |
6.4 cm 2.5 in. |
Disk gangs - Bearing standards: |
Welded, Reinforced |
Disk gangs - Bearing type: |
Oil bath tapered roller |
Disk gangs - Bearing wear plates: |
Standard |
Disk gangs - Front angle: |
3 positions |
Disk gangs - Rear angle: |
3 positions |
Disk gangs - Scrapers: |
Adjustable |
Frame - Duty: |
Heavy |
Frame - Tube size: |
17.8x17.8x0.95 cm 7x7x0.375 in. |
Frame - Type: |
Single offset rigid |
Hitch - Front hitch type: |
Pintle |
Lighting and safety - Lights: |
Yes |
Lighting and safety - Markings: |
SMV |
Lighting and safety - Safety tow chain: |
Yes |
Set-up time - Labor hours: |
2-3 for two people |
Tires - Size: |
385/65R22.5 |
Tires - Type: |
2 - Radial industrial |
Tires - Wheel hub type: |
5-Spoke dayton hubs |
Tractor requirements - Recommended drawbar hp range: |
223.7 kW 300+ hp |
Transport - Wheel hub bearings: |
Dual tapered roller bearings |
Transport - Width: |
4.6 m 15 ft |
Warranty - Time period: |
1 year |
Weight - Net: |
5942.1 kg 13100 lb |
Weight - Weight per disk blade: |
228.2 kg 503 lb |
Working - Approximate working width: |
4.3 m 14 ft |
Transport locks secure disk wings
Transport locks secure disk wings cylinder
Transport locks are standard, ensuring disk wings are in secure transport mode.
Oil bath tapered roller bearings minimize maintenance
Minimal maintenance increases work hours
Sealed with industrial-grade seals
Oil bath tapered roller bearings, sealed with industrial-grade seals, keep maintenance to a minimum and profitable working hours at a maximum. The bearings come complete with a wear plate.
End washers and wrenches keep gang shaft end nut tight
Keeping gangs tightened increases wear life
Gang nut wrenches are always there when needed
End washers help keep the gang shaft end nut tightened during operation, increasing gang wear life.
Two gang nut wrenches are supplied with each unit and securely attached to the unit, ready to use when the gangs need tightening.
Adjustable disk blade scrapers increase productivity
Scrapers clean disk blades
Scrapers work great in wet and sticky soils
Adjustable disk blade scrapers keep disk blades clean and performing in wet and sticky soils for increased productivity.
Two separate control arms create consistent performance
Control arms level in ground and during transport
Easy to set for desired soil condition
Two separate control arms are standard, one for transport leveling and one for leveling while the disk is in the ground. Once set for a given soil condition, the disk will continue to perform with consistency.